Resistance & Components

01Resistance & Components

Resistance and Ohm's law

This section covers resistance, its relationship with current and potential difference, and the conditions under which Ohm's law applies.

Resistance

Resistance describes how strongly a component opposes the flow of electric current. For a conductor it is calculated from the potential difference across the conductor and the current through it:

R=VIR=\frac{V}{I}
Quantity Symbol Unit
Resistance RR ohm, Ω\Omega
Potential difference VV volt, V
Current II ampere, A

A resistance of 1 Ω1\,\Omega corresponds to a current of 1 A1\,\mathrm{A} when the potential difference is 1 V1\,\mathrm{V}.

For a given potential difference, increasing the resistance reduces the current; decreasing the resistance allows a larger current.

Real electrical components and connecting wires have some resistance. Copper is commonly used for wires because its electrical resistance is low.

Exam Tip: Unless a circuit question states otherwise, connecting wires are normally treated as having zero resistance.

Ohm's law

For an ohmic conductor whose physical conditions do not change, the ratio V/IV/I remains constant. Therefore changing the potential difference by a factor changes the current by the same factor:

I∝VI\propto V

For a metal conductor, temperature is an important physical condition. If the current heats the conductor significantly, its resistance changes and the simple proportional relationship no longer applies.

An I–V characteristic can be investigated by changing the resistance in the circuit and recording corresponding values of current through the test component and potential difference across it.

  • The ammeter is connected in series with the test component.
  • The voltmeter is connected in parallel across the test component.
  • The variable resistor is adjusted to change the current and p.d.
"AARRvVV

An ohmic conductor produces a straight-line characteristic through the origin. Resistance can be obtained from the gradient, but the relationship depends on which quantity is on the vertical axis.

Graph Gradient
II against VV ΔIΔV=1R\frac{\Delta I}{\Delta V}=\frac{1}{R}
VV against II ΔVΔI=R\frac{\Delta V}{\Delta I}=R

Exam Tip: Check the axes before using a graph gradient to calculate resistance. For II against VV, use R=1/gradientR=1/\text{gradient}; for VV against II, the gradient itself is RR.

Create a free account to continue

Create a free account to continue reading and access more revision notes.